KeyStrobe-pulserPCB
An upgrade for ANY deck that uses a MAINS strobe light to check speed.
A complete quartz controlled strobe light Super quality PCB based on the KeyStrobe-pulser but without the high voltage circuitry and case
Ideal when an AC or DC supply already exists in deck
Outputs:
100Hz for 50Hz platter
120Hz for 60Hz platters
300Hz for 300Hz markings
Selectable by the switch
Only power source & LED(s) wires to connect
Convenient mounting holes
Wide supply range:
DC 7 volts to 28 volts or
AC 6 volts to 20 volts
Light output remains almost constant over voltage range
Run continuously or switched
Consumes less than 10mA
Employs Optimised Pulse Output for more clearly defined strobe markings.
High accuracy 20ppm crystal
Installation:
DIY mechanical and electrical skills are needed to install this product . A low voltage AC or DC power source is required. If you are not confident, please use the KeyStrobe-pulser
Connecting instructions and general recommendations are supplied but no specific instructions or advice can be given for particular turntables.
An increasing range of turntable-specific kits are available on our Products page.
Comes assembled, tested and calibrated
Supplied with 2 high efficiency orange LED’s and some useful illumination tips
Other colour LED’s available upon request
(currently blue and cool white)
